Power Outage; In Case Of Problems - MURPROTEC CTA Instrucciones De Uso

8. POWER OUTAGE

In the event of a general power outage, the device is reinitialized at the last position recorded in automatic or manual mode
when the circuits are reconnected, except in the case of temporary mode (the device will go into automatic or manual mode
depending on the settings before put in temporary mode).
After a storm or surge in the circuits, the AHU may not start. In such a case, switch off the power supply of the device or the
general power supply for a least one minute than switch it on again.

9. IN CASE OF PROBLEMS

Do not hesitate to contact your installer.
10. WARRANTY
The recourse in warranty must be with Murprotect without fail. Please refer to the conditions of the contract.
The warranty does not apply in the following cases:
• Damage caused by natural phenomena (lightning, flooding, etc.) or from water leaks;
• Shocks, abnormal variations in current voltage, non-compliance with the conditions of use;
• Adaptation of the original installation;
• Repair or intervention other than a change of filter;
• The use of filters other than those provided for this device;
• Adaptation of the filter;
• Non-compliance with the instructions for use;
49