Procedure - MURPROTEC CTA Instrucciones De Uso

7.2.2. Procedure

Step 1 :
The AHU stops automatically when the filter is removed.
So you do not need to switch the device off.
Tip the cover downwards. Remove it so that it does not fall abruptly.
Step 2 :
Remove the dirty filter from its housing. It is retained simply in its slot.
Step 3 :
Place the new filter all the way in its housing (Follow the direction
of the arrow).
Reminder: Use only filters supplied by!
(on pain of cancellation of the warranty)
Step 4 :
Close the cover again.
Step 5 :
Answer "yes" to the question on your control panel by
pressing .
ATTENTION :
• Every time the filter is removed, the control
panel asks you whether you have changed
the filter. Answer YES only if you have put
in a new filter, otherwise you risk disrupting
the AHU completely!
•Intense light may change the way the filter
detection sensor works.
48