Master Plumber 123357 Manual Del Usuario página 8

Bombas de chorro
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Process C, continued.
5. Cement as many couplings and
sections of rigid PVC pipe on both
the pressure and delivery sides as it
takes to equal the depth of your well
minus five feet, then firmly clamp the
assembly with a pipe clamp to prevent
the assembly from sliding down into
the well. Be sure to keep track of which
pipe is the pressure pipe and which is
the delivery pipe.
6. Remove pipe clamp and slide well seal
over PVC pipes and onto well casing.
DO NOT let assembly slide down into
well. Position assembly so that twelve
inches of PVC pipes protrude from
well seal. Using crescent wrench,
turn bolts on well seal clockwise until
rubber gaskets are tight against the
well casing and the PVC pipes.
7. Cut 1" pipe 2" shorter than the
1-1/4" pipe. Smooth rough
edges. Cement 1" and 1-1/4"
PVC elbows to pipes protruding from
the well seal.
8. Thread a 1-1/4" male PVC adapter
into top hole in front of pump.
Thread 1" x 4" nipple into bottom
hole in front of pump. Thread the 1"
female PVC adapter onto the 1" x 4"
nipple.
9. Cement
as many
sections
and
couplings
FEMALE ADAPTER
of rigid 1"
and 1-1/4"
PVC as needed to connect the 1" female PVC adapter and the
1-1/4" male PVC adapter to the 1" and 1-1/4" PVC elbows.
For parts or assistance, call Master Plumber Customer Service at 1-800-628-9439
12" OF
PVC PIPE
PROTRUD-
ING FROM
WELL
SEAL
WELL SEAL
1-1/4" PVC
ELBOW
1" PVC
ELBOW
1" PIPE 2"
SHORTER
THAN 1-1/4"
PIPE
1-1/4" MALE
PVC ADAPTER
1" FEMALE
PVC
ADAPTER
1" x 4"
NIPPLE
1-1/4" PVC PIPE
1" PVC PIPE
10. Open pressure regulator kit. Apply
2-3 wraps of PTFE pipe thread
sealant tape to the male threads on
the body of the pressure regulator.
With pipe wrench, thread the
pressure regulator into 1" discharge at top of pump.
Thread pressure gauge into side of pump case.
11. Thread plug into opening to right of
pressure regulator outlet.
PRIMING DEEP WELL JET PUMPS
12. Complete all electrical connections as specified on pages
2 and 3 in the pre-installation instructions.
13. Thread 3/4" male PVC adapter
into pressure regulator outlet.
14. Thread tank tee into
pre-charged pressure tank.
Plug two outlets on tank tee
with two 1/4" plugs.
15. Thread boiler drain into
front of tank tee.
Thread 3/4" male PVC adapter
into inlet side of tank tee.
Connect to household plumbing.
16. TO PRIME: Remove pressure
regulator, from the top of the
pump case. Fill piping and
pump with water until water
overflows from top of pump.
This may take several minutes.
Put regulator back on pump.
8
PRESSURE
REGULATOR
PRESSURE
REGULATOR
OUTLET
PLUG
3/4" MALE
PVC ADAPTER
1/4" PLUGS
TANK TEE
3/4" MALE
PVC
ADAPTER
1/2" BOILER
DRAIN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

123355123353

Tabla de contenido