Simon, Evers & Co K 484026 Instrucciones De Manejo Y Mantenimiento página 11

The unit has been parked for a
lengthy period with the forks raised
and the rod exposed so that
rust has formed.
The setting screw is not
positioned correctly
4) Leaks
Seals are worn or damaged
Some parts are torn or worn
5) The forks lower without the outlet valve functioning
The outlet valve does not
close properly due to contamination
in the oil
Air is getting into the oil
Seals are worn or damaged
The outlet valve is maladjusted
|

Remove the rust from the rod
and lower the forks as far as possible
when the unit is not in use

Adjust the setting screw (see III.4)

Replace the seals

Check and replace these parts

Replace the oil with fresh oil

Remove the oil (see IV.2)

Replace the seals

Adjust the setting screw