Installation Of Accessories - Commercial Care CCSC30 Manual Del Usuario

OPERATING INSTRUCTIONS

INSTALLATION OF ACCESSORIES

1 . Install the spray cup with hairbrush
Hold the pipe section of the spray cup with hairbrush in your hand, align
the arrow on the spray cup with the single-line mark on short spray
nozzle on the machine body, and insert the spray cup in position. Rotate
the spray cup in clockwise direction, and align the arrow on the spray
cup with the double-line mark on short spray nozzle on the machine
body, as shown in
Figure 1. Fix the spray cup on the machine body. To remove the spray
cup with hairbrush, please rotate the spray cup inversely
(counterclockwise) as shown in
Figure 2. And align the arrow on the spray cup with the single-line mark
on the machine body Then the spray cup with hairbrush can be
pulled out.
2. Install spray cup with round brush or bent spray cup
For direct installation on short spray nozzle, aim the spray cup with
round brush or bent spray cup at the top of spray nozzle, as shown in
Figure 3, and push the spray cup upwards until it is in position. As the
short spray nozzle and spray cup are positioned in six directions, the
angle and direction can be adjusted during the installation. Or, first install
long spray cup and then the spray cup with round brush or bent spray
cup. The long spray cup is installed in the same method as the installation
of spray cup with hairbrush. The spray cup with round brush or bent
spray cup and long spray cup can be installed in the same procedures as
the installation on short spray nozzle.
Page 8
1 2
3