Refilling Water During Operation - Commercial Care CCSC30 Manual Del Usuario

OPERATING INSTRUCTIONS
3. Installation of spray cup for door /window
First install the spray cup with hairbrush on short spray nozzle.
As shown in Figure 4 and Figure 5, install the two small hooks of the
spray cup for door /window onto suspension lugs of the spray cup with
hairbrush, and then trigger the big hook of the spray cup for door /
window, and push the spray cup for door/window up and clutch it onto
the body of the spray cup with hair brush.
CAUTION: Before disconnecting a tool from the steam cleaner, make
certain that steam is no longer coming from the nozzle. Use
an oven mitt to remove tools, or wait until they cool before
removing.

REFILLING WATER DURING OPERATION

1. Unplug the power cord and disconnect the power supply.
2. Press down the steam button to release the pressure until no steam is
injected out.
3. Slowly unscrew the safety cap but do not remove it, and residual steam
will be discharged slowly until no steam comes out. Then place the
machine in a cool place to cool it down for about five minutes. Finally,
completely remove the safety cap.
4. Use the funnel and measuring cup to refill water into the tank.
NOTE: Do not pour more than 200ml of water at any given time.
5. Re-install the safety cap onto the unit and tighten it in position.
CAUTION: Always unplug your steamer before filling/ refilling. Press the
steamer button until the steamer depressurizes. Wait 5 minutes
before removing the cap.
4 5
Page 9