Silvercrest SSJ 300 B3 Instrucciones De Servicio página 32

The device is designed for continuous operation of
... maximum 15 minutes when juicing or
... maximum 5 minutes for sorbet preparation.
After this, the device must remain switched off until it has cooled
down to room temperature.
DANGER for children
Packing materials are not children's
toys. Children should not be allowed to
play with the plastic bags. There is a
risk of suffocation.
Keep the device out of the reach of chil-
dren.
DANGER to and from pets
and livestock
Electrical devices can represent a dan-
ger to pets and livestock. In addition,
animals can also cause damage to the
device. For this reason you should keep
animals away from electrical devices at
all times.
DANGER! Risk of electric
shock due to moisture
The device must never be operated in
the vicinity of a bathtub, a shower, a
filled washbasin or similar items.
The base unit, the power cable and the
mains plug must not be immersed in wa-
ter or any other liquids.
Protect the base unit, the power cable
and the mains plug from moisture and
dripping or splashing water.
Make sure that no liquid gets into the
ventilation slots on the underside of the
base unit.
If liquid gets into the base unit, pull out
the mains plug immediately. Have the de-
vice checked before reusing.
Never touch the device with wet hands.
If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to retrieve the device.
30 GB
DANGER! Risk of electric
shock
Only plug the mains plug into the wall
socket after the device has been com-
pletely assembled.
Only connect the mains plug to a prop-
erly installed and easily accessible
earthed wall socket whose voltage cor-
responds to the specifications on the rat-
ing plate. The wall socket must still be
easily accessible after the device is
plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot spots.
Do not wrap the power cable around
the device.
Keep the power cable away from hot
surfaces (e.g. hot plates).
Even after it has been switched off, the
device is not completely disconnected
from the mains. In order to fully discon-
nect it, pull out the mains plug.
When using the device, ensure that the
power cable cannot be trapped or
crushed.
When removing the mains plug from the
wall socket, always pull on the plug and
never the cable.
Disconnect the mains plug from the wall
socket ...
... if there is a fault,
... when you are not using the device,
... before you assemble or disassemble
the device,
... before you clean the device and
... during thunderstorms.
Do not use the device if there is visible
damage to the device or the power ca-
ble.