Water Connection Requirements - Alliance Laundry Systems HC18MD2 Instrucciones De Instalación

Installation

Water Connection Requirements

Connections should be supplied by a hot and a cold
water line of at least the sizes shown in Table 8.
Installation of additional machines will require
proportionately larger water lines.
To connect water service to machine with rubber
hoses, use the following procedure:
1. Before installing hoses, flush the water system
for at least 2 minutes.
2. Check filters in the machine's inlet hoses for
proper fit and cleanliness before connecting.
3. Hang hoses in a large loop; do not allow them to
kink.
If additional hose lengths are needed, use flexible
hoses with screen filters.
Water Supply Line Sizing
Number
of
Machines
1 3/4 in. (19 mm)
2 1 in. (25 mm)
3 1-1/4 in. (32 mm)
4 1-1/2 in. (38 mm)
1 1 in. (25 mm)
2 1-1/2 in. (38 mm)
3 2 in. (50 mm)
4 2 in. (50 mm)
1 1-1/2 in. (38 mm)
2 2 in. (50 mm)
3 2 in. (50 mm)
4 2-1/2 in. (70 mm)
Table 8
42
Supply Line Size
Main Hot/Cold
1/2 in. (13 mm)
3/4 in. (19 mm)
1 in. (25 mm)
1 in. (25 mm)
3/4 in. (19 mm)
1 in. (25 mm)
1-1/4 in. (32 mm)
1-1/2 in. (38 mm)
1 in. (25 mm)
1-1/2 in. (38 mm)
2 in. (50 mm)
2 in. (50 mm)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Suitable air cushions should be installed in supply
lines to prevent "hammering." Refer to Figure 30.
1
1 Water Supply Faucets
2 Air Cushions (Risers)
Figure 30
2
MW008J
MW008J
F232135