Installing Batteries; Using The Device - Steinberg Systems SBS-MD-12 Manual De Instrucciones

5. Adjust the length of the device to your height so that you can hold it in your hand in
an upright position when you are standing. The search coil should be positioned
approximately 1-5 cm above the ground. Tighten the lock nut.
6. Adjust the search coil angle. Loosen the knobs on the end of the search coil and
adjust it to the desired angle. The search coil should be parallel to the ground. Tighten
the knobs so that the search coil does not rotate or wobble sideways.

INSTALLING BATTERIES

1. Make sure the power supply is turned off.
2. Remove the battery cover.
3. Insert two 9V batteries into the battery compartment according to the polarity
marked inside the compartment.
Note!
If the device will not be used for a long time, remove the batteries.
When low battery is indicated on the control panel display, the battery needs to be
replaced.

USING THE DEVICE

1. Press the POWER button to turn the device on. All symbols will appear on the
display. After about two seconds, the display will show three blank frames with icons
for the detected object. At this point, you can start working with the device. In this
case, the device will detect all types of metal.
2. When the device finds a metal object, it will emit a sound signal and an icon with a
black base will appear on the display. The depth at which the target is located will also
be displayed. However, it should be remembered that this will be an approximate
depth. Actual depth may vary.
3. By using the DISC button you can eliminate the unwanted metal type. You can
eliminate the first and second metal category.