Adjustments: " Settings " Menu; Language; Settings" Menu - Default Parameters; Set Point - Zodiac pH Perfect Instrucciones De Montaje Y De Uso

4

Adjustments: " Settings " menu

A
B
C
D
All manuals and user guides at all-guides.com
4.1.

Language

The default language displayed on the pH Perfect is French.
You can choose between 6 languages for the LCD display: French, English, German,
Spanish, Italian and Dutch.
To change language when in the "Settings" menu, enable the option list by
pressing the "CAL/Enter" button (a small arrow appears on the right of the
screen and the language message flashes). Then select the language using the
"up" and "down" navigation buttons.
Accept the choice by pressing the "CAL/Enter" button.
4.2. " Settings " menu - Default parameters
!
The pH Perfect is factory preset with the following settings
(suitable for most cases):
a. Language: French
b. Set point: pH = 7.4
c. Dosage = acid
(injection when the pH is higher than the set point)
d. " OFA" over- feed protection: 240 minutes
e. Calibration = enabled in 2 points (pH7 & pH4)
f. Detection that filtration is in progress: enabled
However, there is an easily accessible "settings" menu for changing the settings of
your appliance to match them as closely as possible to your pool's requirements.
• To access the "Settings" menu, the appliance must be ON. Simultaneously press
the "CAL/Enter" and "SET/Esc" buttons for about 5 seconds until the LCD
screen displays "Settings".
This "settings" menu gives access to the following adjustments:
– Language

– Set point

– Type of dosage
– Time of using the " OFA" over- feed protection
– Type of calibration
– Detection that filtration is in progress
• To exit the "Settings" menu, press the "SET/Esc" button and select "Yes"
or "No", using the "up" and "down" navigation buttons to save the
new settings or not. Accept the choice by pressing the "CAL/Enter" button.
Figure C.
4.3. Set point
The default set point on the pH Perfect is 7.4 pH.
To change it when in the "Settings" menu, enable the option list by pressing
the "CAL/Enter" button (the pH value flashes). Then select the value chosen
using the "up" and "down" navigation buttons. The adjustment is made in
increments of 0.1 pH.
Accept the choice by pressing the "CAL/Enter" button.
Note: : It is also possible to directly access the set point by holding down the
"SET/Esc" button (keep pressing while changing the setting).
Figure B.
Figure A.
31