Technical Data; Rating Plate - Electrolux EHL6740FAZ Manual De Instrucciones

18 www.electrolux.com
Problem
comes on.
comes on.
comes on.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

9. TECHNICAL DATA

9.1 Rating plate

Model EHL6740FAZ
Typ 60 GAD EA AU
Induction 7.4 kW
Ser.Nr. .................
ELECTROLUX
Possible cause
There is an error in the hob
because a cookware
boiled dry. Automatic
Switch Off and the over‐
heating protection for the
zones operate.
The cooling fan is blocked. Check if objects block the
The electrical connection is
incorrect. The hob is con‐
nected only to one phase.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 596 379 01
220 - 240 V 50 - 60 Hz
Made in Germany
7.4 kW
Remedy
Deactivate the hob. Re‐
move the hot cookware.
After approximately 30
seconds, activate the zone
again. If the cookware was
the problem, the error mes‐
sage goes out. Residual
heat indicator can stay on.
Let the cookware become
sufficiently cool. Check if
your cookware is compati‐
ble with the hob.
Refer to "Hints and tips"
chapter.
cooling fan. If comes
on again, speak to an Au‐
thorised Service Centre.
Speak to a qualified electri‐
cian to check the installa‐
tion. Refer to the connec‐
tion diagram.