Working Instructions - Worx WG800E Traducción De Instrucciones Originales

ASSEMBLy
1. ExTENSION hANDLE(wG800E.2)
Fitting extension handle(See b, C)
Align the grooves on the machine with fixing
on the wheel cart (b).
Plug in the handle connector (a).
Removing extension handle(See C)
To release machine from wheel cart (b), pull
the machine in the direction shown.
Adjusting handle Length(See D)
1 Loosen the adjustment collar.
2 Pull the shaft out to increase the height, or
push the shaft in to decrease the height.
3 Re-tighten adjustment collar.
2. ADJUSTING ThE whEEL
hEIGhT(wG800E.2)
The tool has two wheel height positions for
adjustment.(See E1,E2)
Follow the schedules(See F1,F2):
1)Pull the right wheel outwards and hold it.
2)Turn the wheel 90° .
3)Release the wheel until it locked in the slot.
3. ADJUSTING FOR EDGING
14
MODE(wG800E.2)
For edging mode, you need adjust the wheel
height to lower position (See E2) .
Turn the machine 90°, in either direction to
position the machine in the vertical edging
mode. (See F)
4. SwIVELING ThE hANDLE FOR
COMPACT ShEAR(wG800E.2)
You could use your tool for cutting grass in
compact and limited room by swiveling the
extension handle. (See G)
In the normal operating position, align the
locking sign " " on the knob (10) with the
triangle " ", the extension handle is locked.
Rotate the handle adjust knob, adjust the
unlocking sign " "pointing to the triangle,
make sure the knob is fixed , then the
extension handle can be swiveled free.(See
I1,I2)
5. FITTING/ChANGING ThE bLADE
wARNING! wear gloves when
changing the blade.
Cordless shrub shear and edging shear
All manuals and user guides at all-guides.com
Removing
Press the Tool-free blade cover release button (5).
Remove away from the housing. (See J1)
Lift the blade out. (See J2)
Fitting
Fit the blade as shown aligning the holes in the
blade onto the drive pins.(See K1)
Press the blade cover back to the housing.
(See K2)
OPERATION
1. STARTING AND STOPPING
Starting:
To switch ON your Shear firstly press the Lock
off button(2)then depress the On/Off switch (4)
Stopping:
To switch Off simply release the On/Off switch (4)
NOTE: Follow the above steps when
operating by the extension handle.
when staring the machine. Do not
operation the machine when charging!

2. wORKING INSTRUCTIONS

NOTE: Hold the machine away from yourself.
Stand in a secure and stable position.
a. Shrub shear
Cutting hedges
Before cutting check the hedge for foreign
objects e. g. wire fences.
cut stems up to 8 mm in thickness. When
cutting, move steadily along the line of cut,
so that stems are fed directly into the cutter
blades. The double edge of the cutting blade
enables cutting to either direction, or with a
side to side motion.
After use replace the blade transport guard.
Recommended cutting/trimming times:
– cut hedges with deciduous leaves in June
and October.
– cut evergreen hedges in April and August.
– cut conifer and other fast growing shrubs
approx. every six weeks from May onwards.
b. Shrub shear/ edging shear with
extension handle(wG800E.2)
Edging
Guide the machine along the edge of the
lawn. Do not allow the blade to contact paved
wARNING: the switch (2 and 4)
must be pressed simultaneously
EN