TRAPP TRP 40 Manual De Instrucciones página 47

To operate with dry products
(grains):
Place the sealing cover (1).
✔
Place the green crop feeder cover (5).
✔
Select a suitable strainer (diameters 0,8 - 3 -
✔
5 - 12 mm). The resulting product depends
on the diameter of the strainer used.
The dry product is placed in the grain funnel
✔
(2), and then forwarded to be processed. The
end product leaves the shredder through the
lower part.
Be careful not to overload the motor.
✔
Regulate the grain input adjuster according
to the shredder's capacity to grind and to the
strainer chosen. The regulation of the grain
input adjuster is done in the following way:
loosen the wing nut (3) located underneath
the grain input adjuster. Once the regulator
(4) is free, pull in case you need a bigger
opening, and push in case you need a
smaller opening. After regulating, tighten the
wing nut (3).
Operation
Model TRF 60
45
ENGLISH