Installation; Assembly; Tube Preparation - SOMFY S&SO-RS100 io HYBRID Instrucciones

S&SO-RS100 io Hybrid

2. INSTALLATION


These instructions are mandatory for the home motorisation and automation professional
who installs the S&SO-RS100 io HYBRID drive.

Never drop, knock or puncture the drive or immerse it in liquid.

Install an individual control point for each drive.

2.1. ASSEMBLY

2.1.1. Drive preparation
Mount the accessories needed for integration of
1)
the drive into the winding tube:
• Either only the wheel
• Or the ring
b
Measure the length (L1) between the inside edge of the
2)
drive head and the end of the wheel.

2.1.2. Tube preparation

Cut the winding tube to the desired length depending
1)
on the product to be motorised.
Deburr the winding tube and remove all chips.
2)
For winding tubes that are smooth inside,
3)
cut a notch to the following dimensions:
= 4 mm;
d e
2.1.3. Drive-tube assembly
Slide the drive into the winding tube. For winding tubes
1)
that are smooth inside, position the cut notch on
the protruding part of the ring.
The wheel must be locked in a straight line inside
2)
the winding tube:
• Either by securing the winding tube to the wheel
using 4 Ø 5 mm Parker screws or 4 Ø 4.8 mm steel
pop rivets located between 5 mm and 15 mm from
the outside edge of the wheel, irrespective of the type
of winding tube.
The screws or pop rivets must only be fastened on

the wheel and not on the drive.
• Or by using a wheel lock, for non-smooth tubes.
2.1.4. Mounting the tube-drive assembly
Fit and attach the tube-drive assembly to the end
1)
support and the drive support
f
Make sure that the tube-drive assembly is locked

in place on the end support. This prevents the tube-
drive assembly from coming out of the end support
fixing.
Depending on the type of support, fit the retaining ring
2)
in place.
h
Copyright© 2014-2017 SOMFY ACTIVITES SA, Public Limited Company. All rights reserved.
on the drive.
a
and the wheel on the drive.
c
= 28 mm.
g
1)
2)
1)
3)
1)
2)
1)
:
2)
Ø = 47 mm
a
L1 = ...
L1
2)
d
15 mm
L1
g
h
EN
Ø > 47 mm
b c
e
5 mm
f
51