SOMFY S&SO-RS100 io HYBRID Instrucciones página 60

Ocultar thumbs Ver también para S&SO-RS100 io HYBRID:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 83
EN
For operation with an io-homecontrol
-
For operation with the wired control point only (the io-homecontrol
-
press
or
on the wired control point and check the settings made.
The procedure for modifying the end limit settings is identical to the initial setting procedure. To modify
the settings at a later time, repeat step B2 
b
Step B2 
: Setting / resetting of end limits in semi-automatic mode with the
io-homecontrol
control point
®
This procedure is only applicable to roller shutters without rigid links and with stops, and roller shutters
with rigid links and without stops.
From 3), in set mode:
The roller shutter moves more slowly during the first few seconds of movement.
Position the roller shutter at its half-way position.
1)
On the io-homecontrol
2)
simultaneously, for ≈ 5 s, until there is back and forth
movement by the roller shutter.
The drive is in set mode.
The drive remains in set mode for ≈ 10 min.
Operate the roller shutter and allow it to stop
3)
automatically at the upper end limit (if stops) or lower end
limit (if rigid links).
Press my, for ≈  2 s, until there is back and forth
4)
movement by the roller shutter.
The setting for the first end limit is confirmed.
Move the roller shutter to the desired lower end limit (no
5)
rigid links) or upper limit (no stops).
Press my, for ≈ 2 s, until there are two back and forth movements by the roller shutter.
6)
The setting for the second end limit is confirmed.
The settings for the end limits are programmed.
The drive enters programming mode for ≈ 2 min. if no io-homecontrol
programmed.
For operation with an io-homecontrol
-
For operation with the wired control point only (the io-homecontrol
-
press
or
on the wired control point and check the settings made.
The procedure for modifying the end limit settings is identical to the initial setting procedure.
To modify the settings at a later time, repeat step B2 
Step B3: Programming the Somfy io-homecontrol
If the drive is no longer in programming mode, repeat Step B1, before performing Step B3.
The drive is in programming mode:
Briefly press the PROG button on the Somfy io-homecontrol
-
local control point you want to programme:
The roller shutter moves back and forth: the control
point has been programmed in the drive.
Some control points have an ON/OFF button. To activate them, press the ON/OFF button at
the back of the control point.
58
 control point: go to Step B3.
®
a
.
control point, p
®
 control point: go to Step B3.
®
Copyright© 2014-2017 SOMFY ACTIVITES SA, Public Limited Company. All rights reserved.
®
1)
ress
Λ and V
3)
5)
®
b
.
local control point
®
®
S&SO-RS100 io Hybrid
control point is not programmed):
2)
5 s
4)
2 s
6)
2 s
control point is
®
control point is not programmed):
1 2
4 3
PROG. 0.5 s
x 2

Publicidad

Tabla de contenido
loading

Tabla de contenido