Freestanding Installation; Built-In Installation - Asko T701 Guía De Uso Y Cuidado

All manuals and user guides at all-guides.com
CONNECTING TO A VENTILATION DUCT (T701 AND T761)
1. Connect the exhaust hose to a ventilation exhaust
fitting or to a discharge through the wall.
2. Secure the hose joint to the outlet stub on the
machine.
3. Run the hose with as few bends as possible to the
point of discharge. If necessary, it can be extended to
a maximum of 20 feet (610 cm) of 4" (10 cm) diameter
ridged pipe.
Make any bends as gentle as possible. A maximum of four
90° bends may be fitted in the hose. The more bends and
the longer the hose, the less air will circulate through the
machine, which will impede drying performance. Subtract
4 feet (122 cm) for every 90° elbow.
NOTE: When installing in warm climates (77° F and
above) with high humidity levels, do not
route the air exhaust hose upwards.
If more than 20 feet of hose is needed, the diameter must
be increased to 6" or 8" (152 mm or 203 mm).
Installation Examples

FREESTANDING INSTALLATION

The dryer can be placed next to the washing machine.
It is essential that the machine is leveled and the locknuts
are tight to eliminate vibration noise.

BUILT-IN INSTALLATION

ASKO dryers can be installed beneath a cabinet or
worktop with a minimum height of 34" (864 mm).
There must be a gap of about 1/2" (12 mm) all around
the machine, including between the rear edge of the
machine top panel and the back wall. The opening width
must be at least 24-1/2" (622 mm).
Space must also be available for the exhaust hose on the
left, right or rear of the machine. See the diagram for hole
sizes and positions. Note that the hole measurements
are to the center of the hole.
MODELS T721 AND T781
The condensing models work best when they have good air
circulation. Therefore, we don't recommend they be installed
beneath a cabinet. If it is necessary, however, be sure to
leave a gap of at least 1/2" (12 mm) on all sides.
If you install the dryer so the condensed water will
continuously flow into a drain or sink, you will need a
drain outlet behind the unit. The maximum drain height
is 40" (1016 mm). (See page 4.)
WARNING!
This appliance should not be exhausted into a
chimney, a wall, a ceiling, or a concealed space of
a building. Only a metal ventilation grill should be
used.
If the hose is taken to a wall outlet, a ventilation grill
should be fitted to prevent reverse flow of cold air. Fit the
ventilation grill to the outside or inside of the wall.
Make sure nothing is blocking
the ventilation grill.
If there is only one vent duct from the room, a vent spacer
Subtract 4 feet
must be fitted.
(122 cm) for every
90° elbow.
There should be at least 1/2" (12 mm) of space between
the washer and dryer.
NOTES: The height adjustment for the dryer is
Ventilation grill
Vent spacer
33-1/2" to 34-1/2" (850 mm to 876 mm). Do not
raise it higher than 34-1/2".
Hole measurements are from center of hole.
Page 5