Function Setting Introduction; Menu Setting - MedLinket AM-806 Manual De Instrucciones

3) The attention of Operation
● The equipment should be fully tested to see if it can be used normally before
using.
● The finger should be placed properly (see figure 4 of this manual), or else it may
cause inaccurate measurement.
● The SpO2 sensor and photoelectric receiving tube should be arranged in a way
with the testee's arteriole in a position in between.
● The device should not be used at a location or limb tied with arterial catheter or
blood pressure cuff of receiving intravenous injection.
● Make sure the optical path is free from any optical obstacles like rubberized
fabric; otherwise it may result in venous pulsation and inaccurate measure of SpO2.
● Excessive ambient light may affect the measuring result. It includes fluorescent
lamp, dual ruby light, infrared heater, direct sunlight and etc.
● Strenuous action of the testee or extreme electrosurgical interference may also
affect the accuracy.
● Testee cannot use enamel or other makeup.
● Please clean and disinfect the device after operating according to the user
manual.

Function Setting Introduction

Press the Pulse Oximeter Menu button to power on and access to the testing inter-
face, or press the Menu button repeatedly during normal operation to switch to
parameter-setting interfaces to set up the parameters and then return to the POST
display. Settable parameters include high and low SpO2 limit, high and low bpm
limits, high and pulse beep volume.
The device will power off automatically within 8 seconds when there is no any
signals input, which can also be turned off by using the menu button under parame-
ter-setting interfaces.

Menu Setting

Function
● Power on
Turn on the PULSE OXIMETER by press-
ing the Menu/Power button "
● Power off setting
Short press the button, move the cursor
to select the item of "power off", and
Power "on"
then long press the button to turn the
and "off"
power off.
Note:
The device will power off automatically
within 8 seconds when there is no any
signal input.
Table 1：Instruction for Menu setting
Instruction for operation
English 14
Figures
".
%SpO2 BPM