Installing The Blades - Hinkley TURBINE 904280FCW-LWD Manual Del Usuario

INSTALLING THE BLADES

Fig. 1
10 | hinkley.com
Attach the blade support plates to the blades and blade arms using
the three blade attachment screws. Insert a blade attachment screws
into the blade arm, but do not tighten. Repeat for the two remaining
screws.
Tighten each screw securely starting with the center screw. Make
sure the blade is straight. Repeat these steps for the remaining
blades.
Blade support
Insert the blade assembly through the slot on the housing. Align the
plates
holes on the blade arm and the fan motor assembly and secure
with screws. Make sure screws are TIGHT! Loose motor screws can
Screws
contribute to unnecessary hum during operation.
Blades
Blade arms
Screws
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.