Installing The Light Kit And Glass Shade - Hinkley TURBINE 904280FCW-LWD Manual Del Usuario

INSTALLING THE LIGHT KIT AND GLASS SHADE

Adapter
plate
Light wires
Fig. 1
NOTE: Be sure the power is off before installing.
If you do not plan to install the light kit with your fan at this
time, skip Step 5.
1
Remove one of the three screws on the mounting hub
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 1)
2
Pass the light wires through the center hole of the adapter
plate.
3
Place the key holes on the adapter plate over the 2 screws
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
4
Remove one of the three screws on the adapter plate
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 2)
Mounting hub
(bottom of motor)
Glass shade
or optional
Screws metal cover
Fig. 2
5
While holding the LED light kit under your fan, make the
polarized plug connections: (Fig. 2)
- Red to white
- Black to black
6
Tuck connections neatly into adapter plate. Place the key
holes on the light kit over the 2 screws previously loosened,
turn the light kit until it locks in place at the narrow section of
5
the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
7
Raise the glass shade or metal cover against the LED light kit
and turn clockwise until snug, DO NOT OVERTIGHTEN.
8
Restore power and your light kit is ready for operation.
Wire connectors
Light kit
©2021 Hinkley Lighting, Inc. | hinkley.com |
Adapter plate
Screws
11