Hanging The Fan - Hinkley TURBINE 904280FCW-LWD Manual Del Usuario

HANGING THE FAN

Remove ball from downrod by loosening set screw in the
1
side of the ball. Slide ball down and remove ball pin; remove
ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing
2
with the mounting collar (where the wires come out) facing
upward.
3 Loosen the two security set screws and remove the downrod
pin and retaining clip from the coupling on top of the motor
assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable
4
from the fan through the downrod. Thread downrod into
coupler until holes align. Insert downrod pin through holes
in mounting collar and downrod; clip cotter pin through
small hole in end of downrod pin to hold downrod in place.
5 Tighten security set screws against downrod using a large
flat blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
06 | hinkley.com
Hanger ball
Downrod
Fig. 1
Hook-up (3) wires
Downrod
Mounting collar
Cotter pin
Fig. 2
Cross pin
Set screw
Safety cable
Security screws
Downrod pin