Transport And Storage - Hilti SF 2H-A Manual Del Usuario

All manuals and user guides at all-guides.com
▶ To achieve maximum battery life, stop drawing power from the battery as
soon as a significant drop in the performance of the power tool is noticed.
▶ Charge the batteries using the Hilti chargers approved for use with Li-ion
batteries.

6.3 Transport and storage

WARNING
Fire hazard. Risk of short circuiting.
▶ Never store or transport Li­ion batteries in loose, bulk form.
▶ Remove the battery before transporting or storing the hammer drill/driver.
▶ Observe the nationally and internationally applicable transport regulations
when shipping batteries by road, rail, sea or air.
Note
Ideally, the battery should be stored in a fully-charged state in a dry
place that is as cool as possible. Storing the battery in places subject
to high ambient temperatures (e.g. at a window) has an adverse
effect on battery life and increases the rate of self-discharge.
If the battery no longer reaches full charge, it may have lost capacity
due to aging or overstressing. It is still possible to work with this
battery. You should, however, soon replace the battery with a new
one.
7 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault
The power tool
doesn't run.
The control switch
can't be pressed, i.e.
the switch is locked.
The battery runs
down more quickly
than usual.
30
Possible cause
The battery is not fully
inserted.
Low battery.
The forward/reverse
selector switch is in the
middle position.
Very low ambient tem-
perature.
Action to be taken
▶ Push the battery in
until it engages with
an audible click.
▶ Charge the battery.
▶ Push the
forward/reverse
switch to the left or
right.
▶ Allow the battery to
warm up slowly to
room temperature.