Recommended Spare Parts - Columbus McKinnon CM Bandit BAN07505 Manual De Funcionamiento, Mantenimiento Y Piezas

MAINTENANCE (CONTINUED)
GEAR TIMING
When assembling gears, they must be orientated with the timing
marks orientated as shown. (use figure "Gear Timing") Note: For 1.5
tonne units, orientation of pinion/gear assemblies A and B are not
relevant providing the timing marks are orientated as shown and one
of each (A & B) assembly is present.
Timing Marks
Figure 10 - Gear Timing
(0.75 and 1.5 Tonne)
REPLACING LOAD CHAIN
To replace the load chain, remove the lower hook block and chain
stop from the chain. Move the directional lever to the neutral "N" and
pull the old chain out of the hoist. Feed a length of soft wire through
one side of the chain guide and over the liftwheel until it comes out
on the other side of the chain guide. Attach the wire to the end of the
new chain. Position the chain so that the first link to enter the chain
guide will be an upstanding link and the welds on all upstanding
links will be away from the liftwheel. Pull on the wire until the chain
engages the liftwheel. Turn the free chaining knob, while pulling on
the wire, until the chain comes out of the chain guide. Pull the chain
through and remove the wire. Attach the lower hook block to the
chain that is directly below the upper hook.
Chain guide -
Lower Hook Side
Stripper
Lower
Hook
Block
Chain Installation
Timing Marks
Figure 11 - Gear Timing
(3 and 6 Tonne)
Chain welds
away from
Liftwheel
Liftwheel
Chain guide -
Chain Stop Side
Chain Stop -
Position as Shown

RECOMMENDED SPARE PARTS

Ratchet Disc Assembly
Latch Kit
Upper & Lower Hook Assembly
Alterations or modifications of equipment and use of any
parts other than CM Bandit lever hoist repair parts can lead to
dangerous operation and injury.
TO AVOID INJURY:
Do not alter or modify equipment. Do use only CM Bandit
provided replacement parts.
9
(ENGLISH)
P/N: BANMANUAL REV. AC March 2014