ARGENTO OMEGA+ Manual De Uso Y Mantenimiento página 24

9. LCD configuration
Press the M button for at least two seconds to enter the configuration on the LCD.
Press the + and - buttons in the display configuration to change the value of each parameter;
press the M button to move to the next parameter; press the M button for at least two seconds
to exit the LCD configuration.
Km/Miles
Marked by the S7 symbol, press the + and - buttons to switch from the Km/h to MPH display.
Display backlighting
Marked by the b1 symbol, values allowed: 1-5.
Automatic display switch-off
Marked by the 0F symbol, values allowed: 0-15. The set values correspond to minutes. If the
set value is 0, this function is not enabled.
If the value entered is a value between 1 and 15, the display will automatically switch off after
a set number of minutes.
Wheel diameter
Marked by the Hd symbol, values allowed: 6-34.
The set values correspond to the wheel diameter in inches. For your model, leave the value
on 28, otherwise the values shown on the display when using your bike will be incorrect.
Password - Speed limit
Marked by the Pd symbol. Enter the password "1919" using the + and - buttons; confirm each
single value in the password entered using the M button.
After correctly entering the password, you access the speed limit parameter marked by the
SL symbol, values allowed: 10-100.
Motor parameter
Marked by the HL symbol, make sure that the set value is the number 1. If a different value is
set, the speed may not be correctly displayed.
22