Maintenance; Safety Rules; Cleaning The Machine; Safety Thermostat - Manual Rearming - Bezzera BZ07 DE Manual De Instrucciones

BEZZERA BZ07
MOD.
2b) Turn the main switch on again (Fig. 01; pos.
1) and press the continuous dose button " "
(Fig. 05; pos. c) until the water comes out of
the unit; press the button again " " (Fig. 05;
pos. c) and wait for the machine to become
pressurised.

6 - MAINTENANCE

To allow the machine to work correctly, follow the
maintenance instructions provided below.

6.1 Safety rules

Do not subject the machine to water jets. Disconnect
the machine from the electrical power by turning
the electrical power network omnipolar knife-switch
lever to the resting position 0. Remove the plug and
close the water interception tap before carrying
out maintenance and/or cleaning work. If the
machine is malfunctioning, do not attempt to repair
it alone and call the technical assistance service
immediately. If the electrical power cable has been
damaged, turn off the machine immediately, turn
off the water and call the technical assistance
service. Do not replace it alone. Carry out cleaning/
maintenance when the machine is cold, preferably
wearing protective gloves.

6.2 Cleaning the machine

These recommendations are indicative.
Maintenance and cleaning frequency depends on
machine use.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and filters
Daily
1) Clean the cup holder grill and drain tank
2) Clean the machine body
Weekly
1) Clean the unit seal with the brush provided (Fig.
07).
2) Clean the water tank (S VERSION).
3) Wash the unit as follows: attach the filter holder
to the unit with the blind filter provided (Fig. 10;
pos. 17) and start up distribution several times.
Monthly
1) Submerge the filter holders and filters in boiling
water for a few minutes to dissolve coffee grease,
use a cloth or sponge to remove residue.
Do not use solvents, detergents or
abrasive sponges for washing and
cleaning. Clean the machine body with
Downloaded from CoffeeMachineManual.com Manuals
All manuals and user guides at all-guides.com
a cloth dampened in water and/or neutral
detergents,
reconnecting the machine to the power supply. Use
water to clean the cup holder grill and drain tank.
Use water and neutral detergents to clean the tank
after removing it. When finished rinse thoroughly.
Replace the tank and insert the silicon tubes making
sure that the suction pipe touches the bottom.
6.3
rearming
While the machine is working, the boiler resistance
may overheat and, cutting off power, sets off the
safety thermostat that prevents any further damage
to the boiler. To restore normal operations, resolve
the malfunction that triggered the safety thermostat
and restore normal conditions by pressing the red
button (RESET) (Fig. 08).
6.4 Correct product disposal (electrical
and electronic waste)
(Applicable in the European Union countries and
those countries with separate waste collection
systems).
cycle. To avoid any damage to the environment or
to health, caused by unsuitable waste disposal, the
user is asked to separate this product from other
types of waste and to recycle it responsibly to help
the sustainable recycling of material resources.
Domestic users are invited to contact the dealer
where the product was purchased or the local
office in charge of this matter for all the information
relating to separate waste collection and recycling
for this type of product.
Company users are invited to contact their own
supplier to check the terms and conditions of the
purchase contract.
This product must not be disposed of together with
other commercial waste.
26
carefully drying
Safety thermostat
Warning!
The operation described below
is only relevant to an installing
technician who is authorised by
the manufacturer.
The sign carried on the product or on its
documentation indicates
product must not be disposed of with
other domestic waste at the end of its life
surfaces before
- Manual
that the