Care And Cleaning; Removing The Seat Cover - Cybex Platinum CLOUD Q Manual Del Propietário

REMOVING THE SEAT COVER

The integrated Harness System cannot be removed
from the seat. NEVER remove or attempt to remove
parts of the Harness System.
DO NOT damage, remove or dispose of any EPS foam.
NEVER use Infant Carrier without a properly installed
Seat Cover.
To remove please follow these steps:
1. Undo the belt buckle.
2. Unsnap the two Shoulder Pads from the harness.
3. If using the Infant Insert, simply unsnap the two
snaps holding it around the harness straps.
4. Pull the Headrest Cover over the edge.
5. Unsnap the two snaps connecting to the Backrest Cover.
6. Unsnap the two snaps creating the harness slot.
7. Unsnap the two black snaps holding the canopy
fabric and push canopy forward.
8. Unsnap the three gray snaps from the top of the plastic shell.
9. Unsnap two silver dual action snaps- same as for canopy straps.
10. Unthread fabric around European Belt Buckle
and LSP devices, then pull up over the top.
11. Pull forward and over the side wings, unsnap 2
gray snaps and 2 silver snaps connecting to Leg
Support Cover, as well as 2 gray snaps connecting
to plastic shell and remove the Backrest Cover.
12. Fully recline seat, unsnap opening for hip belt
and lift fabric over the side. Finally thread Crotch
Buckle through the Crotch Buckle Pad.
45

CARE AND CLEANING

INSTALLING THE SEAT COVER
Reverse the removal instructions to reinstall the Seat Cover.
BACKREST COVER
HEADREST COVER
SHOULDER PADS
LEG SUPPORT COVER