Usage; Transport - Hallins 75 Manual

machine with a guard. We recommend that a hazard analysis is prepared based on the
Machinery Directive for the relevant working situation.
 A load must not be present on the load carrier for inspections, service and repairs.
 The lifting trolley's drive unit is located beneath protective housing. This may only be
removed by personnel qualified to carry out inspections, service, and repairs.
 Only Hallins original spare parts may be used when replacing parts. Failure to observe
this may nullify the warranty obligation in full.
 Handle spent batteries as hazardous waste, and dispose of them at a designated place.
 Observe crushing risk between the load bed and supporting legs, and between load bed
and mast.
 Refer additionally to Signs, Chapter 14. Check regularly to ensure the signs are intact.

7 USAGE

In order to utilise the qualities of the lifting trolley to the greatest effect and to prevent injury,
it is vital that you read through these instructions carefully and that you use the trolley in
the correct way.
Mechanical construction
The lifting trolley 75 consists of a mast with accompanying chassis and battery unit with
charger. Lift is achieved through a battery driven motor that transfers the lift force to the
lifting device via a chain.
The driving handle is designed for a range of grips.
Two (2) maintenance-free batteries 12 V DC, and charger for connection to single phase,
230 V, 50 Hz power point are included.
See Section 6, "Safe use", with respect to safe conditions and risks
when handling the machine and its load!

7.1 Transport

The lifting trolley is fitted with four easy-turning, revolving wheels of which two function as
parking brakes. When the lifting trolley is not being used for moving, the brakes on the two
wheels that have brakes must always be applied. The load bed must always be in its
lowest position when transporting goods with the lifting trolley.
Never transport goods when the load bed is in
raised position.
7.2 Manoeuvring the load bed
The main switch must be ON in order to manoeuvre
the load bed.
8