Fault Tracing - Hallins 75 Manual

12 FAULT TRACING

The lifting trolley 75 has been designed and tested to achieve optimal operational
reliability and service life, under the proviso that routine maintenance is carried out in
accordance with the specified instructions. If despite this a problem should occur, use the
fault tracing table below to obtain relevant guidance.
Remove the load from the load bed before any troubleshooting and repairs.
Inspections, service and repairs must be carried out by qualified personnel.
If problems persist after you have taken the measures specified in the list below, you
should contact an authorised repairman or your supplier.
Symtom
Load bed does not move on signal A. Read the error code on the battery indicator,
Troubleshooting list
When repairs have been carried out to the lifting trolley, conduct a full performance
test with full load before using the trolley again.
Procedure
see the troubleshooting list below.
B. Check that the lifting trolley's control unit and
cable stand are not defective
C. Connect the power cable to the mains and let it
remain on charge for at least 8 hours.
D. If the load bed does not move after the measure
specified in point B, contact an authorised repair
shop and/or your supplier.
13