Simon, Evers & Co 41-484027-PX001 Instrucciones De Manejo página 7

8. NEVER OVERLOAD THE UNIT.
9. NE VER LOAD THE PLATFORM ON ONE SIDE OR MAKE IT TOP-
HEAVY OR PLACE LOADS THAT STICK OUT OVER THE EDGE
OF THE PLATFORM.
10. THE CAPACITY OF THE UNIT ASSUMES THAT THE
LOAD
TRANSPORT WITH THE CENTRE OF GRAVITY IN THE
CENTRE OF THE FORKS AT THE FRONT.
11. ENSURE THAT THE LENGTH OF THE FORKS IS THE
SAME AS THE LENGTH OF THE PALLET.
12. LOWER THE FORKS AS FAR AS POSSIBLE WHEN THE UNIT IS
NOT IN USE.
II.Inspection and maintenance instructions
Safety warning
Before inspection and maintenance work is carried out, appropriate measures
should be taken to remove all loads from the electric high-lift pallet truck.
Maintenance and inspection work
Check operating elements for faultless operation.
Check condition of the travelling rollers and roller axles
Grease joints and bearings
Check functioning of wheels and rollers
Check all screw and bolt connections for tightness
Check all parts of the pallet truck for wear and replace defective
parts where necessary
Check readability of type plate.
Authorise inspection by competent technical expert
The service life of yourhigh-lift pallet truck is limited. Worn parts must be
renewed in adequate time.
WILL BE PERFECTLY BALANCED FOR
Inspection intervals
2