Installation; Positioning - SCHOLTES TEPPAN YAKI F Manual De Instrucciones

Installation

! Please keep this instruction booklet in a safe place for
GB
future reference. If the appliance is sold, given away or
moved, please sure the booklet is also passed on to the
new owners so that they may benefit from the advice
contained within it.
! Please read this manual carefully: it contains important
information concerning the safe operation, installation
and maintenance of the appliance.

Positioning

! Keep all packaging material out of reach of children. It
may present a choking or suffocation hazard ( see
Precautions and tips ).
! The appliance must be installed by a qualified
professional in accordance with the instructions
provided. Incorrect installation may damage property or
cause harm to people or animals.
Built-in appliance
Use an appropriate cabinet to ensure that the appliance
operates properly:
• the supporting surface must be heat-resistant up to a
temperature of approximately 100°C;
• avoid installing the hob above a dishwasher: if this
cannot be avoided, place a waterproof separation
device between the two appliances;
• depending on the hob you want to install ( see figure ),
the cabinet must have the following dimensions:
Installing semi-flush hobs (TEPPAN YAKI SF)
All the necessary precautions must be taken in order
to install the appliance in conformity with current
accident-prevention regulations (CEI-UNI-CIG)
relating to gas and electrical connections. To ensure
sit-on hobs installed in kitchen cabinets operate
correctly, the minimum distances indicated should
be observed (see figure). All adjacent surfaces and
the back panel should also be able to withstand an
overheating temperature of 65°C.
10
All manuals and user guides at all-guides.com
TEPPAN YAKI SF
50 min
Securing the appliance to the cabinet
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could
alter the features and the operation of the hob.
• Before fitting the hob to the worktop, position the
seal provided along the perimeter of the hob, as
illustrated in the figure.
• The installation cavity should have the dimensions
indicated in the figure accompanying the previous
paragraph.
Fix the hob as follows:
1. Use the screws supplied to fit the 4 alignment
springs in the holes provided at the central point of
each side of the part underneath the hob.
2. Place the hob in the cavity, make sure it is in a
central position and push down on the whole
perimeter until the hob adheres well to the
supporting surface.
! The screws for the alignment springs must remain
accessible.
! In order to adhere to safety standards, the
appliance must not come into contact with electrical
parts once it has been installed.
700 min
50 min