Electrical Connection - SCHOLTES TEPPAN YAKI F Manual De Instrucciones

FRONT SIDE OF HOB
UNDERSIDE
OF HOB
! All parts that ensure the safe operation of the
appliance must not be removable without the aid of
a tool.
! Where the hob is not installed over a built-in oven, a
wooden panel must be installed as insulation. This
must be placed at a minimum distance of 20 mm from
the lower part of the hob.

Electrical connection

Hobs equipped with a three-pole power supply
cable are designed to operate with alternating
current at the voltage and frequency indicated on
the data plate (this is located on the lower part of the
appliance). The earth wire in the cable has a green
and yellow cover. If the appliance is to be installed
above a built-in electric oven, the electrical
connection of the hob and the oven must be carried
out separately, both for electrical safety purposes
and to make extracting the oven easier.
Single-phase connection
If the hob has a supply cable fitted, connect it to the
mains, using the colours as a guide (see adjacent
The yellow-green wire should be 5 cm
diagram).
longer than the other wires.
All manuals and user guides at all-guides.com
Connecting the electricity supply cable to the
mains
Blue Brown
SUPPORTIN G
SURFAC E
N
wire must not be interrupted by the switch). The
supply cable must be positioned so that it does not
come into contact with temperatures higher than
50°C at any point.
! The installer must ensure that the correct electrical
connection has been performed and that it is fully
compliant with safety regulations.
Before connecting the appliance to the power
supply, make sure that:
• the appliance is earthed and the plug is compliant
• the socket can withstand the maximum power of
• the voltage falls within the range of values
• the socket is compatible with the plug of the
! Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only.
! The manufacturer declines any liability should
these safety measures not be observed.
The appliance must be directly
Green/Yellow
connected to the mains using an
omnipolar switch with a minimum
contact opening of 3 mm installed
between the appliance and the
mains. The switch must be
suitable for the charge indicated
and must comply with current
electrical regulations (the earthing
L
with the law;
the appliance, which is indicated on the data
plate located on the appliance itself;
indicated on the data plate;
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.
GB
11