NuWave OXYPURE ZERO Manual Del Propietário página 11

WIFI CONNECTION
The OxyPure is equipped with Wi-Fi allowing you to operate the OxyPure
®
from any location. To set up and activate the Wi-Fi:
Download the NuWave
1.
Play on your smartphone or device and open the app.
Make sure your phone is connected to your network. Open the
2.
app and follow the instructions for the verification process. Once
verification is complete, begin adding devices. To add a device, tap "+"
then select "OxyPure."
Next, plug the OxyPure into a compatible power outlet. To activate Wi-
3.
Fi Pairing Mode, press and hold ULTIMATE CLEAN on the OxyPure
for 2 seconds until the light next WIFI begins to blink at a rate of about
2 blinks per second. Once the Wi-Fi light is rapidly blinking, in the app,
tap the Finish Network Configuration button on the bottom of the Add
Device page.
Next, you will be prompted to either connect to your network or confirm
4.
your existing network password.
Note: To either connect to or change networks, depending on your cellular
service, you may need to remove the app and reinstall it to complete the
connection before continuing with the setup process.
When the OxyPure is connected to the Wi-Fi, the light next to "WIFI" will
5.
stop flashing and stay continuously lit.
If the OxyPure did not connect to your network, the WIFI light will turn
6.
off. Repeat steps 3-4. Make sure to select the proper Wi-Fi network and
type the correct password.
Note: The OxyPure, as with most IoT devices (computing devices), will only
connect to a 2.4GHz* network.
7. To reset the OxyPure WIFI, press and hold down ULTIMATE CLEAN
for 3 seconds. Follow Step 4 (see above). The OxyPure can now be
operated from any location.
*Most routers will broadcast in 2.4GHz. If you need help activating 2.4GHz,
contact your ISP (Internet Service Provider).
Connect app via the Apple Store or Google
® ™
11
nuwavenow.com