Bluetooth Connection - NuWave OXYPURE ZERO Manual Del Propietário

WIFI CONNECTION
Solid Light
The OxyPure is paired with the Wi-Fi and ready to be used.
®
Rapid Blinking Light
The OxyPure is in Pairing Mode. The OxyPure will remain in Pairing Mode
for up to 3 minutes, or until your device is paired.
Slow Blinking Light
The OxyPure is in Standby Mode.
No Light
The OxyPure's Wi-Fi is off.
Note: If the light on your OxyPure is blinking slower, the OxyPure is in Wi-Fi
Standby Mode. To exit Standby Mode and initiate the Pairing Mode, press
and hold POWER for 2 seconds until the Wi-Fi light begins blinking rapidly.

Bluetooth Connection

The OxyPure Wi-Fi module also offers back-up Bluetooth connectivity.
If your Wi-Fi network goes down, the OxyPure's Bluetooth signal will
automatically pair with your Bluetooth device.
To take advantage of this feature, ensure that your smart device's
Bluetooth, Wi-Fi and Mobile Data options are all enabled.
Pairing your device with the OxyPure via Bluetooth takes up to 5 minutes,
but once your device is paired, the NuWave Connect app will operate
normally within the range of the Bluetooth signal.
Before Use:
1. Make sure the OxyPure
panel on the back to expose the filters.
2. Pull the filters from their slots.
3. Remove the plastic wrapping from the filters.
4. Fully reinsert the filters into the Oxypure and close
the panel.
5. Remove the sticker from the control panel, making sure
to fit the sensor tabs into their corresponding slots.
12
wifi connection
Wi-Fi LED Status
Pairing Mode & Standby Mode
is unplugged. Open the
®