NuWave OXYPURE ZERO Manual Del Propietário página 23

CLEAN FILTER Indicators have not reset after the filter(s) have
been cleaned.
1. The Filter Sensor is not reading the clean filter. Turn the OxyPure
then on again. Press and hold down "TIMER" for 2 seconds until a
beep is heard.
2. Turn the OxyPure off, unplug and adjust the filter(s). Plug in and turn
the OxyPure on again.
3. The Filter Access Panel in back rear is not securely in place. Make
sure Filter Access Panel is on securely.
4. The Filter Sensor is dirty. Clean the Filter Sensor.
ULTIMATE CLEAN does not come on when pressed.
The OxyPure is not reading the function selected. Turn the OxyPure on
and off by pressing POWER twice.
Power is blinking red.
When the Filter Access Panel is removed, the power icon will be back-
lit solid red. Pressing POWER will make it blink. However, as a safety
measure, the OxyPure will not operate when the Filter Access Panel is
removed. Ensure that Filter Access Panel is installed securely.
The Odor Sensor is not resetting itself and the indicator light
is not clearing.
Contact Customer Service at 1-877-689-2838 or
email help@nuwavenow.com.
Air and Odor LEDs
The OxyPure will display the Air/Odor quality from Clean to Dirty as
represented below. If the contamination in the air exceeds Dirty (red LED), a
warning alert will be triggered by both a beeping sound and flashing LED.
To turn off this warning, press AUTO and Fan Speed at the same time.
Press the same buttons to turn the warning feature on.
Clean
off
®
Dirty
nuwavenow.com
23