Mounting The Fan Blades And Cover Switch Cup Assembly - Fanimation The Zonix FP4640-220 Serie Manual Del Propietário

Mounting the Fan Blades and Cover Switch Cup Assembly

WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Securely fasten the three blades with phillips-head
screws with flat washers. (Figure 14)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
2. Disassemble switch cup support cover from cover
switch cup assembly removing three screws.
(Figure 15)
3. Remove one of the three screws in the support
bracket. Attach the switch cup support cover to the
support flange by rotating plate and properly positioning
screws in key slots. Install third screw in remaining hole.
Fully tighten all three screws. (Figure 16)
4. Securely attach 9-pin connector from motor
assembly to wiring harness socket within switch cover
assembly. (Figure 17)
WARNING
The color label on these two connectors must
correspond to each other.
All manuals and user guides at all-guides.com
8
Phillips-Head
Screw with
Blade Screws
Flat Washer
(3 per blade)
Figure 14
Switch Cup
Support Cover
Figure 15
Figure 16
Figure 17