Festo 8131016 Instrucciones De Utilizacion página 13

•
Always use power supply cables with appropriate measurements when replacing
removable power supply cables (length = 2.5 m, 3x1 mm2 with ground contact).
•
Make sure that connecting cables are not subjected to continuous tensile loads.
•
When laying connecting cables, make sure they are not kinked or pinched.
•
Do not lay connector cables over hot surfaces.
–
•
Devices with a ground terminal must always be grounded.
–
–
• When replacing fuses, always use specified fuses with the correct current rating and
tripping characteristics.
•
The device is not equipped with a built-in fuse unless otherwise specified in the
technical data.
•
Safe operation of the device is no longer possible in the event of any of the
following issues:
–
–
–
–
–
–
© Festo Didactic 8134684
Hot surfaces are identified with a corresponding warning symbol.
If a ground terminal (green-yellow laboratory socket) is available, it must always
be connected to the protective grounding. The protective grounding must
always be connected first (before the voltage) and disconnected last (after
disconnecting the voltage).
Some devices have high leakage current. These devices must be fitted with a
grounding conductor for additional grounding.
Visible damage
Malfunction
Inappropriate storage
Incorrect transport
Switch off the power supply immediately.
Protect the device to prevent it from being restarted accidentally.
Robotino 4 Charging Station – Operating instructions
CAUTION
CAUTION
13