Adjusting The Height Of The Docking Plug - Festo 8131016 Instrucciones De Utilizacion

Robotino 4 Charging Station – Operating instructions

7.4 Adjusting the height of the docking plug

Depending on the condition of the ground under the device, you may need to adjust the height of the
docking plug contacts on the charging station.
Proceed as follows:
1. Undo the three screws that connect the cover of the charging station to the housing. Make sure that no
small parts fall into the device during installation.
2. Do not remove the cover completely. The marker cable is plugged in.
3. Undo the four screws on the inside of the housing that hold the docking plug in place.
4. Align the contact surfaces with the plug of the Robotino 4.
5. Once this is done, fix the four screws in place.
6. Replace the cover and fasten it in place using the screws.
7. Plug the power supply cable back into the charging station's IEC plug.
8. Switch the charging station on.
Figure 9: 4 screws for adjusting the height of the docking plug
22
© Festo Didactic 8134684