Specifications; Intent Of Use; Tool Specification - Stanley AV 734 Serie Instrucciones Originales

O R I G I N A L I N S T R U C T I O N

2. SPECIFICATIONS

2.1 INTENT OF USE

The AV™15 Installation Tool is principally a piston and cylinder assembly. When coupled hydraulically and electrically to a
compatible hydraulic power source and the relevant nose assembly is attached, it is then used to install 1/2" Avdelok® XT
and 1/2" Avbolt® in Industrial Environments.
The placing tool and hydraulic pump unit may only be used in accordance with the operating instructions for placing Stan-
ley Engineered Fastening structural rivets.
Refer to the table below for the list of applicable fasteners and associated nose equipment.
Refer to the datasheets listed in the table for the relevant nose assembly instructions.
DO NOT use under wet conditions or in the presence of flammable liquids or gases.
FASTENER
TYPE
AVBOLT®
AVDELOK® XT
*Nose assembly with jaw release.
Refer to the illustration on page 8 for the identification of the nose assembly dimensions 'A' and 'B' .
The safety instructions must be followed at all times.

2.2 TOOL SPECIFICATION

Force:
Pressure:
Stroke:
Weight:
Hydraulic Oil:
Product Range:
Additional Features:
SIZE
1/2"
1/2"
SPECIFICATION
Pull at stated pull pressure
Push Off at stated return pressure
Pull
Return
Piston Stroke
Without nose equipment
Enerpac® Hydraulic Oil – HF-95X
Avbolt®
Avdelok® XT
Stem Ejection – Front or Rear
Seal Arrangement
Hydraulic Bearing Rings
Protective Handle / Hose Gator
Protective Hose Guard
Hose / Cable Retention Clamps
NOSE ASSEMBLY
PART NUMBER DIM. 'A'
73432-03100 108 mm
73433-03100* 108 mm
73432-03200 107 mm
73433-03200* 107 mm
NOSE ASSEMBLY
DATASHEET
DIM. 'B' PART NUMBER
43 mm 07900-00905
43 mm 07900-00905
43 mm 07900-00919
43 mm 07900-00919
METRIC IMPERIAL
80.0 kN 17984.7 lbf
37.0 kN 8317.9 lbf
510 bar 7397 PSI
200 bar 2901 PSI
32.0 mm
4.5 kg
12.7 mm
12.7 mm
Rear
Twin Lip and Wiper Seals
Yes – Front and Rear
Yes
Yes
Yes
E N G L I S H
1.26 in
9.9 lb
1/2 in
1/2 in
7