Panels; Custom Panels - Sub-Zero Designer Serie Guia De Instalacion

Panels

Stainless Steel Panels
The outdoor model requires the use of Sub-Zero stainless
steel outdoor accessory panels.
The thickness of indoor stainless steel panels is 3/4"
outdoor stainless steel panels is 1 1/2"
designer model is 24" . Allow for panel thickness when
(610)
planning the finished opening depth.
Reveals of 1/8" are typical, however, the reveal between
(3)
the upper and lower outdoor stainless steel panels is 1/4"
to accommodate the lock.

Custom Panels

For designer models, custom door/drawer panels and
handle hardware must be installed.
The thickness of the custom panel can vary. A minimum
5/8" thick panel is required, but the thickness can be
(16)
increased provided it does not exceed the maximum panel
weight indicated in the chart below. The depth of each
designer model is 24" . Allow for panel thickness when
(610)
planning the finished opening depth.
PANEL REQUIREMENTS
WEIGHT PER PANEL
18" Column
24" Column
30" Column
36" Column
WEIGHT PER PANEL
30" Tall (door)
36" Tall (door)
Drawer
PANEL THICKNESS
All Panels
12 | Sub-Zero Customer Care 800.222.7820
and
(19)
. The depth of each
(38)
(6)
MAX
45 lb
(20 kg)
60 lb
(27 kg)
75 lb
(34 kg)
75 lb
(34 kg)
MAX
50 lb
(22 kg)
60 lb
(27 kg)
15 lb
(7 kg)
MIN
5/8"
(16)
Reveals between panels can vary, 1/8"
CAUTION
When installing a panel thicker than 1"
door stop may be required to prevent damage to the
unit and adjacent cabinetry.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while the door is
closing.
Finish all sides of the custom panels. They will be visible
when the door/drawer is open.
D-style handles are recommended. Locate the door
handle near the edge of the panel opposite the hinge and
centered top to bottom. Locate the drawer handles near
the top edge of each panel. Stainless steel tubular and
pro handles are avail able through an authorized Sub-Zero
dealer.
reveals are typical.
(3)
, the 90°
(25)