Changing The Lights - F.Bertazzoni 36FDFZXNT Instrucciones De Instalacion Y Uso

Connecting the water line
Water line installation kits are available as an
additional accessory from your dealer or at a local
hardware store.
1) Shut off the main water supply line.
2) Install a 1/4" water line with a shut-off valve (UNS
7/16-24) that will remain accessible once the product
is in place. Refer to local codes and instructions on the
water line installation kit (not included).
3) Connect the newly installed water supply line (C)
to the refrigerator's water inlet connector (B) then
tighten using tool.
4) Gently tug on the water supply line to ensure it is
securely installed, thus avoiding the risk of damage
when pulling the unit out or pushing it back while
cleaning.
5) Turn the main water supply line back on and check
for leaks.
6) After connecting the water line, flush one gallon of
water through the filter before drinking or using the
water from your refrigerator. (Flush for approximately
5 minutes). To flush, press a large glass or cup against
the water dispenser lever. Fill the glass, then empty
it. Repeat until you have dispensed about one gallon
of water.
B
A
A
B
C

2.8 Changing the lights

Any replacement or maintenance of the LED lights
is intended to be performed by the manufacturer, its
service agent or a similar qualified person.
EN
15