Removing The Refrigerator Doors/Drawers - F.Bertazzoni 36FDFZXNT Instrucciones De Instalacion Y Uso

3.4 Removing the refrigerator doors/
drawers
In some cases you may need to remove the doors and
drawers to move the refrigerator through a doorway.
The doors can be removed by the following the steps
below.
DO NOT REMOVE THE DOORS/DRAWERS UNLESS IT
IS NECESSARY.
Water line locking ring
Figure 1
1) Use a screwdriver to remove the 3 screws, and
then remove the upper hinge cover of the left door.
See Figure 1.
2) Press the water line locking ring into place, then
pull the left door water line out of the connector by
hand. See Figure 2.
Figure 3
3) Use the screwdriver to unscrew the 3 screws and
the 1 grounding screw securing the upper hinge,
remove the plug terminal, then remove the left door.
See Figure 3.
4) The right door has no grounding screw. Otherwise,
follow the same steps as for the left door.
Removing the Quattro Temp Zone drawer
Figure 4
22
1) Open the Quattro Temp Zone drawer and pull it out
as far as it will go.
2) Lift the near end of the tray by grasping both sides,
one in each hand. See Figure 4.
3) Pull the whole tray towards you about 5/8" until the
support claws of the slide rails are separated from the
tray.
4) Remove the tray from the side rails.
5) Remove the harness cover with a screwdriver or
Figure 2 other appropriate tool. See Figure 5.
6) Remove the harness clamp with a screwdriver and
unplug the connecting terminal. See Figure 6.
7) Remove the screws on the left and right slide guide
supports and have a second person hold the Quattro
Temp Zone drawer for support.
8) Lift and angle the Quattro Temp Zone drawer, then
pull with both hands to remove.
Harness Cover
Figure 5
Figure 6
Screws