Hach MET ONE 6000 Serie Manual Básico Del Usuario página 7

Figure 1 Product overview
1 Power input and communication
1
connector, 10-pin
2 Vacuum source fitting (or quick-
connect fitting)
3 Sample air inlet fitting
4 Status indicator light (Table 1)
5 Service port and optional light stack
port
1
6 DIP switch, network address
1
All units except Ethernet
2
Ethernet units only
Table 1 Status indicator light
Color Indication
Green Flashing (3 seconds)
On
6 English
All manuals and user guides at all-guides.com
7 Relative humidity (RH) and
temperature sensor port
8 Vacuum source fitting (alternate
location)
2
9 Connection indicator lights
(Table 2)
2
10 Ethernet RJ45 connector
2
11 Power input connector, 5-pin
System status
Normal, sampling
Normal, not sampling
Table 1 Status indicator light (continued)
Color Indication
Blue On
One short flash, one long flash
Flashing
Red On or flashing
Yellow On
Flashing
Purple Flashing
1
The user-supplied central monitoring software can be used to make the yellow
light flash when a count alert occurs with ModBus protocol, not FX protocol.
The count alert settings are selected with the central monitoring software.
Table 2 Ethernet indicator lights
Color Indication
Yellow On
Green Off
On
Isokinetic probe
For the best accuracy in laminar flow environments, always use the
supplied isokinetic probe with this instrument. The velocity of air in the
probe is similar to that of a typical vertical or horizontal laminar flow
environment such as a clean room or clean hood. The supplied
isokinetic probe supplies the same vertical (or horizontal) flow speed of
the air in order to collect representative samples of the clean room
laminar flow for the instrument. Refer to
sampling with and without the isokinetic probe.
System status
Sensor failure
Air flow failure
Communication failure
Count alarm
Initialization
1
Count alert
Setup utility is being used
Status
Connected
10Base-T
100Base-T
Figure 2 for a comparison of