Migatronic SIGMA ROBO Guía De Usuario página 12

Connection and operation
Switch on, press, weld
Welding program setting.
• Switch on the welding machine on the main switch (2)
• Select welding program
1
MENU
9
# /9
2
PROG
See program table
• Adjust the welding current and secondary parameters
• The machine is now ready to weld
WARNING
Voltage is present on the welding
wire when pressing the welding
hose trigger.
Please read how this
should be selected on your
welding machine in the
quick guide. Select the
welding program suitable
for the welding wire and
shielding gas or possible
electrode in use.
Please read your quickguide
Various wire feed units
i
MENU
9 15.
/9
#
0.0
MENU
9
/9
#
Software reading
• Insert the SD card
• Turn on the machine
• Wait until the LED at the front of the RWF
starts flashing
• Turn off the machine and remove the SD card
• The machine is now ready for use
All connected wire feed units, power source and RCI
will be updated with the new software.
The software can be downloaded from
www.migatronic.com
Licence SW
If additional licences for programs or special
functions have been bought, then the MigaLic.dat
files should be read by the machine in the same way
as SW-packages. Please remember to save a backup
file.
The MigaLic.txt file contains information about
licence number and containing licences at the SD-
card.
12
RWF² 1
1
MENU MENU
9 15. 9
/9 /9
# #
0.0
1
15.0
V
0.0 V
6.2 m/min 5.0 mm
125
A
unit
2
2
RWF² 2
2
15.
0.0