www.evolutionpowertools.com
Fig. 13
Fig. 14
CUTTING ANGLE (BEVEL) ADJUSTMENT
This machine has the facility to tilt the blade through (up to) 50
to the left hand side. Bevel cuts are therefore possible.
Note: The blade is at the vertical position when the angle scale
scale reads 0
.
0
Note: An angle scale (0
- 50
0
Locking quadrant found at the front of the soleplate. Using this
will aid rapid bevel angle setting but should be regarded as a
guide only.
If a very precise bevel angle is required, then the blade setting
should be checked using a vernier angle gauge (not supplied)
and adjusted accordingly.
• Loosen the Bevel Locking Mechanism found at the front of
the machine, by pulling the lever upwards. (Fig. 13)
• Tilt the blade to the required angle as indicated on the
quadrant angle scale. (Fig. 14)
• Tighten the Bevel Locking Mechanism securely when the
desired bevel angle has been achieved by pushing the lever
downwards.
OPERATING ADVICE
(PRE OPERATION CHECKS)
Note: As all operating environments will be unique and
diverse, Evolution Power Tools offers the following general
advice on safe operational procedures and practices for the
consideration of the operator.
This advice cannot be exhaustive as Evolution has no influence
on the type of workshops or working environments in which
these machines may be used.
We recommend that the operator seeks advice from a
competent authority or the workshop supervisor if they are
unsure of any aspect of using these machines.
It is important that routine safety checks are carried out (at
each time of usage) before the operator uses the machine.
WARNING: These pre-use safety checks should be carried out
with the battery removed from the machine.
• Check that all safety guards are operating correctly, and that
all adjustment handles/screws are securely tightened.
• Check that the blade is secure and installed correctly. Also
check that it is the correct blade for the material being cut.
• Whenever possible clamp the workpiece to a rigid support
structure such as a workbench, saw horse or similar.
15
) is incorporated on the Bevel
0
0
EN