On/Off Trigger Switch; Cutting Advice - Evolution F165 CCSL Instrucciones Originales

Fig. 15
www.evolutionpowertools.com
Note: All CCS series machines are equipped with a cutting line
debris blower. This directs air from a motor driven fan towards
the area to the front of the blade, thus keeping the cutting line
relatively debris free.
This feature will aid the operator sight and follow the progress of
the saw blade along the cut, keeping any marking-out
lines visible.
WARNING: Any and all dust created is potentially prejudicial to
health.
Some materials can be particularly harmful, and the operator
should always wear a dust mask which is suitable for the material
being worked with.
Professional help and advice should be sought if the operator is
at all unsure about the potential toxicity of the material to be cut.
WARNING: These machines must never be used to cut Asbestos
or any material that contains, or is suspected to contain,
Asbestos.
Consult/inform the relevant authorities, and seek additional
guidance if Asbestos contamination is suspected.

ON/OFF TRIGGER SWITCH

(16)
Note: All the CCS family of circular saws are equipped with
a 'safety start' trigger switch to enhance operator safety. (Fig.15)
To start the motor:
• Push in the safety lock button on the side of the handle with
your thumb.
• Depress the trigger switch.
To stop the motor:
• Release the trigger switch.
WARNING: The motor should never be started with the saw
blade in direct contact with any surface of the workpiece.

CUTTING ADVICE

(17)
WARNING: The operator must always be aware of the position
and routing of the power cable. The cable must be routed in
such a way that there is no possibility of
the blade coming into contact with the mains cable.
The cable should not pose a trip (or any other type) of hazard to
the operator or any bystanders.
• Do not force the machine.
• Allow the speed of the saw blade do the work. Cutting
performance will not be improved by applying excessive
pressure to the machine and blade life will be reduced.
• When using the parallel edge guide, ensure that it is parallel
14