Publicidad
Idiomas disponibles
Idiomas disponibles
About the mounting instructions
These mounting instructions come as part of the Duravit
product and should be read carefully prior to installation.
Target readership and qualifications
The product and associated water connection should only be
installed by qualified plumbers. The electrical installation
should only be carried out by qualified electricians.
Explanation of the signal words and symbols
DANGER
WARNING
CAUTION
NOTICE
Link to the Electrical Installation section
Link to the Installation Information in this
section
Link to the Water Installation section
Link to other Instructions
Inspection (e.g. for scratches)
Check settings
Inspect for leaks and that all connections have a
watertight seal
>
Action required
4
Mounting_SeWa_Starck f_1pWC_CN_RE_57340/19.10.1
Indicates a hazardous situation which,
if not avoided, will result in death or
serious injury.
Indicates a hazardous situation which,
if not avoided, could result in death or
serious injury.
Indicates a hazardous situation which,
if not avoided, could result in minor
or moderate injury.
Is used to address practices not
related to physical injury.
Safety instructions
Risk of fatal electric shock!
> Disconnect electrical components from the power supply
before the installation.
> Prevent the power supply line from being switched on
accidentally by third parties.
> Connect the product only to the specified power supply.
> NEVER touch the power supply cable with wet hands.
> When working on electric components, disconnect the power
supply.
Product and/or property damage
> Do NOT install the product in a room exposed to excessive
moisture. Ensure sufficient ventilation to avoid condensation
in electric components.
> Only use the parts in the installation kit to avoid
malfunctions.
> Do NOT use attachments not recommended by Duravit.
Freezing water
If the room temperature is too low, this can cause damage to
the product.
> Do NOT install the product in rooms where there is a danger
of frost. The room temperature must not be less than
4 °C (39 °F).
Standards and regulations
The breach of local and country-specific regulations and
standards can cause damage to the product and/or property
damage.
> Local installation regulations, country-specific standards
and the Low Voltage Directives shall be observed at all times.
Mounting instructions
Please read the pre-installation information sheets prior to the
installation. These are available to download on the Internet at
www.pro.duravit.com.
+
1
22
Inspection
> Inspect product for any potential damage that may have
occurred during transport.
> Do not install if any damage is visible.
+
2
23
Shut-off valve and closet flange
> Install shut-off valve and closet flange according to
instructions.
> Observe the technical drawing of the position of
electrical connection.
+
10
32
Risk of external leaks!
NOTICE
Risk of external leaks!
> Do not lift or rock the toilet after placement.
> If you break the watertight seal, you must install a new
wax seal.
+
14
36
Risk of product damage!
NOTICE
Risk of product damage!
> Overtightening may cause breakage or chipping of
vitreous china.
> Handle with care.
Publicidad
