General Description; Charge Modes - GYS GYSFLASH S 1.12 PL Manual De Uso

Operating manual
Do not operate on 230V - risk of explosion!

GENERAL DESCRIPTION

The Gysflash S 1.12 PL is designed to charge lead-acid batteries (Gel, AGM, Liquid, ...) and lithium of the Lithium Iron Phosphate (LFP / LiFePO4).
commonly used for motorcycles, water scooters and many other small vehicles.
This charger is suited for the charge of:
- Lead-acid batteries 12 V (6 elements in series of 2V) from 2 Ah to 32 Ah, and up to 100 Ah for charge support.
- The charge 12V LFP batteries (4 cells in series of 3V) from 0.5 Ah to 20 Ah, and up to 50 Ah for charge support.
START UP
1. Connect the charger to the battery using the proper accessory (clamps, lugs, etc...).
2. Plug the charger to the mains (single phase 100-127 Vac 50-60 Hz).
3. Select the mode by pressing the
4. During the charge, the device indicates the charge progress. When indicator
stays on, the battery is fully charged.
5. The charge can be interrupted at any time by unplugging the mains plug or pressing the
6. After the charge, disconnect the charger from the mains, then disconnect the clamps from the battery.

CHARGE MODES

• Modes and Options description :
• Load curve Lead:
The Gysflash S 1.12 PL uses an advanced 7-step lead charging curve that guarantees the optimal performance of your lead battery.
1
U
I
Analysis
< 1s
CHARGE
OK
10
Translation of the original
instructions
button. After roughly five seconds, the charge starts automatically.
Lead CHARGE mode (14.4 V/1 A) :
Mode for charging 12 V lead-acid batteries from 2 Ah to 32 Ah and up to 100 Ah for charge support.
Automatic seven step charge cycle.
COLD/AGM option (14.7 V/1 A) :
Option to change the charging voltage to 14.7 V for battery charging in cold weather (less
than 5°C) or for some AGM batteries or batteries with plugs.
Lithium CHARGE mode (14.4 V/1 A) :
Mode for charging 12 V lithium batteries from 0.5 Ah to 20 Ah and up to 50 Ah for charge retention. Auto-
matic charging cycle in eight steps.
Some Lithium batteries incorporate a UVP protection (Under Voltage Protection) which
disconnect the battery in case of deep discharge. This protection prevents the charger from
detecting the battery. In order for the Gysflash S 1.12 PL to be able to charge the battery, it is
necessary to deactivate the UVP protection. To do this, select the Lithium charging mode and
press the button
and automatically start charging.
2 3
Recovery Test Desulfation
max 8h < 1s
blinks, the battery is ready to start the vehicle. Once indicator
for 10 seconds. The charger will then deactivate the UVP protection
4 5
Charge
max 12h max 25h
GYSFLASH S 1.12 PL
button.
6 7
Floating
Absorption
charge
max 8h
no limit