Operation; Using The Appliance As A Steam Cleaner; Using Dust Vacuum And Steam - Lavor GV EGON VAC Manual Del Usuario

7.1 Using the appliance as a steam cleaner

Please refer to the chapter "Starting up the boiler" before use.
Press the main switch (D) and the boiler switch (E), the
respective pilot lights (H) and (I) will come on. Water will start
heating up and steam will then be produced (Fig. 5).
Pre-select the amount of steam using the knob (J) located on
the appliance (Fig. 6).
The gauge (K) indicates the pressure inside the boiler: the
grey/silver area indicates the ideal pressure for use (Fig. 7).
When the pilot light (F) comes on, the appliance will be ready
to function with steam. Now press the lever (29) on the
handgrip (26) (Fig. 8).
The first amount of steam will come out with water
condensation; direct the jet to one side or onto a cloth.
The handgrip (26) has a safety lock (32) which prevents steam
from accidentally escaping (Fig. 9):
• left lock: the lever is free
• right lock: the lever is locked
Note: To obtain the correct quantity of steam, wait 3-4 minutes
for the water to heat up.

7.2 Using dust vacuum and steam

CAUTION! Do not vacuum without microfibre filter (P)
installed.
• Microfibre filter (P): it has high filtering capacity and allows
perfect dust vacuum and steam.
CAUTION! Do not vacuum without HEPA filter (X) installed.
• HEPA air filter (X): it has very high filtering capacity and
filters fine dust ensuring output air quality. Periodically
inspect by lifting the hooking lever. See section
""MAINTENANCE"" (Fig. 61)
Note: the tank (M) must be empty and dry.
• To turn the vacuum cleaner on and off, press and hold the
suction button (30) for approx. 2 seconds.
To select suction power (from 1st to 4th level), shortly press the
suction button (30) on the handgrip (26) several times; the LED
(31) corresponding to the selected power level lights up
(Fig. 9)
36

7 OPERATION

D E F G H I
26
29
30
32
Fig. 5
J
Fig. 6
K
Fig. 7
Fig. 8
30
32
Fig. 9
31
32
Fig. 10
EN