Upholstery Nozzle - Lavor GV EGON VAC Manual Del Usuario

UPHOLSTERY NOZZLE (20)

Fig. 39
• Fit the upholstery nozzle (20) (Fig. 39) into the handgrip (26) or extension tube (2).
It has a steam diffuser and a suction nozzle. Two different fittings can be attached to it:
• wiper attachment (21) for hard and smooth surfaces and window wiper function.
• bristled attachment (22) for armchairs and sofas, etc.
The attachments are snap-fit on the upholstery nozzle (20) (Fig. 40) (Fig. 41).
To disassemble the attachment, press with your thumb on the LOWER part, to disengage the
attachment hooking teeth (Fig. 42).
CAUTION!
Significant temperature changes between the window glass and the steam can cause glass
breakage.
In case of cold outdoor temperatures, pre-heat the glass by dispensing steam at a distance of
30-50cm.
Then spray steam on the entire surface of the glass to compensate for temperature changes and
avoid tension on the glass surface.
Using wiper attachment (21), window wiper function:
• Wiper the window cleaner on the surface from top to bottom.
• To dry, vacuum by placing the rubber band of the wiper on the surface.
• For slightly dirty surfaces, use steam and suction at the same time.
WARNING:
To avoid dripping from the attachment, stop dispensing steam and continue vacuum for a few
moments to allow the liquid to flow back up the suction ducts.
After each cleaning operation, clean the rubber band of the wiper with a clean cloth. Only a
clean, well stretched band allows a window cleaning without stripes.
EN
Fig. 40 Fig. 41 Fig. 42
43