Assembly - Attaching The Blades; Attaching The Fan Blades - Home Decorators Collection ACKERLY 59210 Guía De Uso Y Mantenimiento

Assembly - Hanging the Fan (continued)
4
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra
length off from the wires coming from the ceiling fan.
☐ Gently wrap the excess wire around the mounting bracket.
☐ Secure with electrical tape.

Assembly - Attaching the Blades

1

Attaching the fan blades

☐ Attach a blade (F) to the fan-motor housing (E) by
inserting the blade (F) into slots in the side of the fan
motor housing (E) and aligning the three screws holes
in the blade with the holes in the center flywheel and
secure with screws (AA).
☐ Make sure all the screws are firmly tightened.
☐ Repeat these steps for the remaining blades.
5
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
☐ Align the locking slots of the ceiling canopy (C) with the two
screws (EE) in the mounting bracket (A). Push up to engage
the slots and turn clockwise to lock in place.
☐ Firmly tighten the two mounting screws (EE).
☐ Install the two mounting screws (FF) (saved from Assembly
Step 1 "Preparation for standard mounting") into the holes in
the canopy (C) and tighten firmly.
☐ Install the decorative canopy ring (GG) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
10
EE
A
GG
E
E
AA
F