Screwdriver Safety Warnings; Functional Description; Depth Adjustment - Makita 6807 Manual De Instrucciones

ENGLISH
(Original instructions)
1 Locking sleeve
2 Approximately 1 mm
3 Locator
4 Switch trigger
SPECIFICATIONS
Model
Capacities
Self drilling screw ........................................High: 6 mm
Drywall screw .............................................High: 5 mm
–1
No load speed (min ) .............................High: 0 – 2,200
Overall length .................................................... 318 mm
Net weight .............................................................. 2.2 kg
Safety class ............................................................
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
Explanation of general view
5 Lock button
6 Reversing switch lever
7 Speed change knob
8 Pointer
6807

SCREWDRIVER SAFETY WARNINGS

1.
Low: 8 mm
Low: 5 mm
Low: 0 – 1,000
2.
/II
3.
4.
5.
SAVE THESE INSTRUCTIONS.
ENE033-1
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
ENF002-2
failure to follow the safety rules stated in this instruc-
tion manual may cause serious personal injury.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
GEA010-1
tool.

Depth adjustment

The depth can be adjusted by turning the locking sleeve.
Turn it in "A" direction for less depth and in "B" direction
for more depth. One full turn of the locking sleeve equals
1.5 mm change in depth. (Fig. 1)
Adjust the locking sleeve so that the distance between
the tip of the locator and the screw head is approximately
1 mm as shown in Fig. 2 or 3. Drive a trial screw into your
material or a piece of duplicate material. If the depth is
still not suitable for the screw, continue adjusting until you
obtain the proper depth setting.
9 Bit
10 Magnetic bit holder
Hold power tool by insulated gripping surfaces,
when performing an operation where the fas-
tener may contact hidden wiring or its own cord.
Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
Hold the tool firmly.
Keep hands away from rotating parts.
Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
GEB017-4
3